Hyundai Elantra: Engine Electrical System
- General Information
- Ignition System
- Charging System
- Components and Components Location
- Description and Operation
- Schematic Diagrams
- Repair procedures
- Troubleshooting
- Alternator Description and Operation
- Alternator Specifications
- Alternator Components and Components Location
- Alternator Schematic Diagrams
- Alternator Repair procedures
- Battery Description and Operation
- Battery Specifications
- Battery Components and Components Location
- Battery Repair procedures
- Battery Troubleshooting
- Battery Sensor Description and Operation
- Battery Sensor Repair procedures
- Starting System
- Description and Operation
- Troubleshooting
- Starter Description and Operation
- Starter Specifications
- Starter Components and Components Location
- Starter Schematic Diagrams
- Starter Repair procedures
- Starter Relay Repair procedures
- Cruise Control System
- Description and Operation
- Schematic Diagrams
- Troubleshooting
- Cruise Control Switch Components and Components Location
- Cruise Control Switch Schematic Diagrams
- Cruise Control Switch Repair procedures
- Smart Cruise Control System
- General Safety Information and Caution
- Schematic Diagrams
- Description and Operation
- Smart Cruise Control Unit Description and Operation
- Smart Cruise Control Unit Specifications
- Smart Cruise Control Unit Schematic Diagrams
- Smart Cruise Control Unit Repair procedures
- Smart Cruise Control Switch Components and Components Location
- Smart Cruise Control Switch Schematic Diagrams
- Smart Cruise Control Switch Repair procedures
Muffler Repair procedures
Removal and Installation
Front Muffler
1.
Disconnect the battery negative terminal.
2.
Disconnect the oxygen sensor connector (A).
3.
Detach the rubber hanger (A) from the front muffler.
...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Camshaft Position Sensor (CMPS) Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification : Refer to "Wave Form"
Removal
•
DON’T remove the camshaft position sensor during engine
running or right after engine stops, or a scald by the flowed out engine
...
Hyundai Elantra AD (2016-2020) Service Manual: Rear Wheel Speed Sensor Repair procedures
Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from front hub .
Tightening torque:
107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)
•
Be careful not to dama ...
