Hyundai Elantra: Charging System / Battery Sensor Repair procedures

Removal
1.
Disconnect the battery negative (-) cable.
2.
Disconnect the battery sensor connector (A).
3.
Remove the battery negative (-) cable after removing the bolts (B).

Installation
1.
Install in the reverse order of removal.

Battery sensor cable installation bolt :
10.8 ~ 13.7 N.m (1.1 ~ 1.4 kgf.m, 8.0 ~10.1 lb-ft)
Battery (-) terminal tightening nut :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Battery Sensor Description and Operation
Description Vehicles have many control units that use more electricity. These units control their own system based on information from diverse sensors. It is important to have a stable power s ...

Starting System
...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Troubleshooting
Troubleshooting Ignition System SymptomSuspect AreaRemedyEngine will not start or is hard to start (Cranks OK)Ignition lock switchInspect ignition lock switch, or replace as requiredIgnition coilInspect ignition coil, or replace as requiredSpark plugsInspect spark plugs, or replace as requir ...

Hyundai Elantra AD (2016-2020) Service Manual: Heater Unit Components and Components Location
Component Location 1. Heater unit assembly Compoents 1. Shower duct [LH]2. Heater core cover3. Heater core & Seal assembly4. Mode actuator5. Temperature control actuator [LH]6. PTC Heater7. Heater unit pad8. Air guide [LH]9. Heater case [LH]10. Evaporator core assembly11. Heater core ...

В© 2018-2026 www.helantraad.com