Hyundai Elantra: Charging System / Battery Description and Operation

Hyundai Elantra AD (2016-2020) Service Manual / Engine Electrical System / Charging System / Battery Description and Operation

Description

[AGM Battery]

AGM battery is used for especially heavy load on the vehicle network depending on equipment and requirements. AGM stands for Absorbent Glass Material Battery; that is absorbent glass fibre fleece. AGM batteries are fitted in models with electrical loads/consumers which have a high energy demand.

The constantly increasing energy demand of modern vehicle electrical systems calls for ever more powerful battery solutions.

The power consumption is considerable even when the vehicle is parked.

The somewhat higher price compared with a battery of similar size is fully balanced by the following benefits:

-	Significantly longer service life

-	Increased starting reliability at low temperatures

-	100 % freedom from maintenance

-	Low risk in event of an accident (reduced risk to the environment)

Alternator Repair procedures

Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the drive belt. (Refer to Engine Mechanical System - "Drive Belt") 3. Disconnect the alter ...

Battery Specifications

Specifications ?AGM60L-DIN ItemSpecificationModel typeAGM60L-DINCapacity [20HR/5HR] (AH)60/48 Cold Cranking Amperage (A)640 (SAE) 512 (EN)Reserve Capacity (Min)100 ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Theft-Alarm System
This system helps to protect your vehicle and valuables. The horn will sound and the hazard warning lights will blink continuously if any of the following occur: - A door is opened without using the remote key or smart key. - The trunk is opened without using the remote key or smart key. - The ...

Hyundai Elantra AD (2016-2020) Service Manual: 35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check that the ...