Hyundai Elantra: Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Engine Control/Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Inspection

Check signal waveform of CKPS and CMPS using a scan tool.

Specification : Refer to "Waveform"

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the crankshaft position sensor connector (A) and remove the sensor after removing the installation bolt.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Apply the engine oil to the O-ring.

•	Insert the sensor in the installation hole and be careful not to damage.

Installation is reverse of removal.

Crankshaft position sensor installation bolt :

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Crankshaft Position Sensor (CKPS) Schematic Diagrams

Circuit Diagram ...

Camshaft Position Sensor (CMPS) Description and Operation

Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects the pisto ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Specifications
Specifications Fuel Delivery System ItemsSpecificationFuel TankCapacity50 lit. (13.2 U.S.gal., 52.8 U.S.qt., 44.0 Imp.qt.)Fuel FilterTypePaper typeFuel Pressure RegulatorRegulated Fuel Pressure355 ~ 365 kPa (3.4 ~ 3.7 kgf/cm?, 48.6 ~ 52.9 psi)Fuel PumpTypeElectrical, in-tank typeDriven byEle ...

Hyundai Elantra AD (2016-2020) Owners Manual: Sunvisor
To use a sunvisor, pull it downward. To use a sunvisor for a side window, pull it downward, unsnap it from the bracket (1) and swing it to the side (2). To use the vanity mirror, pull down the sunvisor and slide the mirror cover (3). Adjust the sunvisor forward or backward (4) as needed. Use t ...