Hyundai Elantra: Starting System / Starter Relay Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Engine Electrical System / Starting System / Starter Relay Repair procedures

Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the fuse box cover.
3.
Remove the starter relay (A).

4.
Using an ohmmeter, check that there is continuity between each terminal.
Terminal
Continuity
30 - 87
NO
85 - 86
YES

5.
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87.

6.
If there is no continuity, replace the starter relay.
7.
Install the starter relay.
8.
Install the fuse box cover.
Starter Repair procedures
Removal 1. Disconnect the battery negative terminal. 2. Remove the battery tray. (Refer to Engine Electrical System - "Battery") 3. Remove the air duct and air cleaner assembly. (Refe ...

Cruise Control System
...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Check Tire Pressure
â–  Supervision cluster You can check the tire pressure in the Assist Mode on the cluster. Refer to the "LCD Display Mode" section in chapter 3. A "Drive to display" message will appear for the first few minutes of driving after initial engine start up. If the tire ...

Hyundai Elantra AD (2016-2020) Service Manual: Crash Pad Lower Panel Components and Components Location
Component Location 1. Crash pad lower panel ...

© 2018-2026 www.helantraad.com