Hyundai Elantra: Brake System / Brake System
- Repair procedures
- Brake Booster Components and Components Location
- Brake Booster Repair procedures
- Vacuum Pump Components and Components Location
- Vacuum Pump Repair procedures
- Master Cylinder Components and Components Location
- Master Cylinder Repair procedures
- Brake Line Components and Components Location
- Brake Line Repair procedures
- Brake Pedal Components and Components Location
- Brake Pedal Repair procedures
- Front Disc Brake Components and Components Location
- Front Disc Brake Repair procedures
- Rear Disc Brake Components and Components Location
- Rear Disc Brake Repair procedures
- Rear Drum Brake Components and Components Location
- Rear Drum Brake Repair procedures
- Stop Lamp Switch Components and Components Location
- Stop Lamp Switch Schematic Diagrams
- Stop Lamp Switch Troubleshooting
- Stop Lamp Switch Repair procedures
Troubleshooting
Troubleshooting
Problem Symptoms Table
Use the table below to help you find the cause of the
problem. The numbers indicate the priority of the like cause of the
problem. Check each part in o ...
Repair procedures
Operation and Leakage Check
Check all of the following items:
ComponentProcedureBrake Booster (A)Check brake operation by applying the brakes during a test
drive. If the brakes do not work prope ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Components and Components Location
Components
NoConnector AConnector BConnector CConnector D1Batt (+)IGNRain sensor (LIN)Airbag unit (LIN)2IGN 1Front wiper switch (High)-RPAS (LIN)3IGN 2Light switch-Puddle lamp4Brake switchHead lamp switch (High)-ATM solenoid5Front wiper switch (Low)Auto light power-Power windo ...
Hyundai Elantra AD (2016-2020) Service Manual: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).
4.
Measure resistance between sensor signal terminal and sensor ground terminal.
5.
Check that the ...
