Hyundai Elantra: Engine Control System / Heated Oxygen Sensor (HO2S) Description and Operation

Hyundai Elantra AD (2016-2020) Service Manual / Engine Control/Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) Description and Operation

Description

Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Catalytic Converter. It varies in accordance with the air/fuel ratio.

The sensor must be hot in order to operate normally. To keep it hot, the sensor has a heater which is controlled by the ECM via a duty cycle signal. When the exhaust gas temperature is lower than the specified value, the heater warms the sensor tip.

Knock Sensor (KS) Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the knock sensor connector (A). 3. Remove the intake manifold. (Refer to Engine Mech ...

Heated Oxygen Sensor (HO2S) Specifications

Specification HO2S [Bank 1/Sensor 1] (Linear type) ItemSpecificationHeater Resistance (?)2.4 ~ 4.0 [20°C(68°F)] HO2S [Bank 1/Sensor 2] (Binary type) A/F Ratio (?)Output Voltage(V)RICH0.6 ~ 1 ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Rear Combination Light Bulb Replacement. Inside lamp
■ Type A Type A (1) Tail lamp (2) Stop/Tail lamp (3) Turn signal lamp (4) Side marker (5) Back-up lamp ■ Type B Type B (1) Stop (LED) (2) Tail lamp (LED) (3) Turn signal lamp (4) Side marker (LED) (5) Back-up lamp Outside lamp 1. Open the trunk lid. 2. Remove the service co ...

Hyundai Elantra AD (2016-2020) Owners Manual: Aluminum wheel maintenance
The aluminum wheels are coated with a clear protective finish. NOTICE Do not use abrasive cleaner, polishing compound, solvent, or wire brushes on aluminum wheels. Clean the wheel when it has cooled. Use only a mild soap or neutral detergent, and rinse thoroughly with water. Also, cle ...