Hyundai Elantra: Heating, Ventilation and Air Conditioning / Air Conditioning System
- General Safety Information and Caution
- Description and Operation
- Repair procedures
- Components and Components Location
- Compressor oil Repair procedures
- Refrigerant Line Components and Components Location
- Refrigerant Line Repair procedures
- Compressor Description and Operation
- Compressor Components and Components Location
- Compressor Repair procedures
- Condenser Components and Components Location
- Condenser Repair procedures
- Receiver-Drier Repair procedures
- A/C Pressure Transducer Description and Operation
- A/C Pressure Transducer Repair procedures
- Evaporator Temperature Sensor Description and Operation
- Evaporator Temperature Sensor Repair procedures
- In-car Sensor Description and Operation
- In-car Sensor Repair procedures
- Photo Sensor Description and Operation
- Photo Sensor Repair procedures
- Ambient Temperature Sensor Description and Operation
- Ambient Temperature Sensor Repair procedures
- Auto Defogging Sensor Description and Operation
- Auto Defogging Sensor Repair procedures
- Cluster Ionizer Components and Components Location
- Cluster Ionizer Description and Operation
- Cluster Ionizer Repair procedures
General Safety Information and Caution
Instructions
When Handling Refrigerant
1.
R-134a liquid refrigerant is highly volatile. A drop on the
skin of your hand could result in localized frostbite. When handling the
refrigerant, be ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Smart Key Unit Components and Components Location
Components (1)
NoConnector AConnector BConnector C1BAT (+)_SignalDriver's door antenna_GND-2BAT (+)_PowerDriver's door antenna_Power-3IGN 1--4IGN 2_Relay outputB-CAN (High)SSB LED (OFF)5IGN 1_Relay outputB-CAN (Low)SSB LED (IGN)6Assist door antenna_GNDWheel speed sensorSSB LED (ACC)7Interior an ...
Hyundai Elantra AD (2016-2020) Service Manual: Intake Air Temperature Sensor (IATS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the specification.
Specification : Refer to "Specification"
...
