Hyundai Elantra: Air Conditioning System / Auto Defogging Sensor Description and Operation

Hyundai Elantra AD (2016-2020) Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Auto Defogging Sensor Description and Operation

Description

The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intake actuator, A/C, auto defogging actuator, blower motor rpm, and mode actuator.

Ambient Temperature Sensor Repair procedures

Inspection 1. Check the resistance of the ambient temperature sensor between terminals 1 and 2 whether it changes by changing the ambient temperature. 1. Ambient Sensor (+)2. Sensor ground ...

Auto Defogging Sensor Repair procedures

Diagnosis With GDS 1. The heating, ventilation and air conditioning can be quickly diagnosed failed parts with vehicle diagnostic system (GDS). ? The diagnostic system (GDS) provides the follow ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Engine Cover Repair procedures
Removal and Installation 1. Remove the engine cover (A). • To avoid damage, remove the engine cover on room temperature. • To avoid damage of the engine cover, do not disengage both front and rear mounting point at the same time. 2. Install in the rev ...

Hyundai Elantra AD (2016-2020) Service Manual: Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. ConditionOutput Voltage (V)IG ON3.9 ~ 4.1Idle0.8 ~ 1.6 Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disco ...