Hyundai Elantra: Air Conditioning System / A/C Pressure Transducer Description and Operation
Hyundai Elantra AD (2016-2020) Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / A/C Pressure Transducer Description and Operation
| Description |
The A/C Pressure Transducer (APT) converts the pressure value
of high pressure line into voltage value after measuring it. By
converted voltage value, engine ECU controls the cooling fan by
operating it high speed or low speed. Engine ECU stops the operation of
the compressor when the temperature of refrigerant line is very high or
very low irregularly to optimize air conditioning system.
Receiver-Drier Repair procedures
Replacement
1.
Remove the condenser.
2.
Remove the cap (A) on the bottom of the condenser with a L wrench.
Tightening torque :
9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)
...
A/C Pressure Transducer Repair procedures
Inspection
1.
Measure the pressure of high pressure line by measuring voltage output between terminal “1” and “2”.
2.
Inspect the voltage value whether it is sufficient to be regular v ...
Other information:
Hyundai Elantra AD (2016-2020) Owners Manual: Fuel Filler Door
Opening the fuel filler door
The fuel filler door must be opened from inside the vehicle by pulling up the
fuel filler door release lever.
1. Turn the engine off. Locate the fuel filler door release lever on the floor
on the left side of the driver seat.
2. Pull up on the release lever.
...
Hyundai Elantra AD (2016-2020) Service Manual: Radiator Repair procedures
Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester.
2.
Apply a pressure of 93.16 ~ 122.58 kPa (0.95 ~ 1.25 kgf/cm?, 13.51 ~ 17.78 psi).
3.
Check for a drop in pressure.
4.
If the pressure drops, re ...
© 2018-2026 www.helantraad.com
