Hyundai Elantra: Heater / Auto Defoging Actuator Specifications

Hyundai Elantra AD (2016-2020) Service Manual / Heating, Ventilation and Air Conditioning / Heater / Auto Defoging Actuator Specifications

Specifications

Door position	Voltage (V)	Error detecting
Max. cooling	0.3 ± 0.15	Low voltage : 0.1V or less
Max. heating	4.7 ± 0.15	High voltage : 4.9V or more

Auto Defoging Actuator Description and Operation

Description The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control modul ...

Auto Defoging Actuator Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. Verify that the auto defogging actuator operates to the open position when connecting 12V to ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspection. Test Conditions Symp ...

Hyundai Elantra AD (2016-2020) Service Manual: Components and Components Location
Component Location 1. Audio unit2. Feeder cable joint connector3. Center speaker4. Glass antenna amplifier5. Front door speaker6. Rear door speaker7. Sub woofer speaker8. Antenna feeder cable9. Tweeter speaker ...