Hyundai Elantra: Air Conditioning System / In-car Sensor Description and Operation

Hyundai Elantra AD (2016-2020) Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / In-car Sensor Description and Operation

Description

The In-car air temperature sensor is built in the heater & A/C control unit.

The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to heater control unit and according to this signal the control unit regulates in-car temperature to intended value.

Evaporator Temperature Sensor Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure the resistance between terminal "+" and "-" of the evaporator temperature ...

In-car Sensor Repair procedures

Diagnosis With GDS 1. The heating, ventilation and air conditioning can be quickly diagnosed failed parts with vehicle diagnostic system (GDS). ? The diagnostic system (GDS) provides the follow ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: AVN(Audio Video Navigation) head unit Components and Components Location
Components Connector Pin Information NoConnector AConnector BConnector C1-Multmedia-CAN (High)Chassis-CAN (Low)2--Chassis-CAN (High)3---4-Steering wheel remote controller-5SPDIF Shield GND--6SPDIF (+)MTS keypad signal-7---8Illumination (+)AUX R input-9-Multimedia jack (GND)- 10-MIC (+)-11-Batt ...

Hyundai Elantra AD (2016-2020) Service Manual: Rear Door Belt Inside Weatherstrip Repair procedures
Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Remove the rear door belt inside weatherstrip (A). 3. To intall, reverse the removal procedure. • When installing, install it by first contacting the inside part (basis point ...