Hyundai Elantra: Air Conditioning System / Compressor oil Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Compressor oil Repair procedures

Oil Specification

1.	The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed.

2.	Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the model of compressor.

Handling of Oil

1.	The oil should be free from moisture, dust, metal powder, etc.

2.	Do not mix with other oil.

3.	The water content in the oil increases when exposed to air. After use, seal oil from air immediately. (HFC-134a Compressor Oil absorbs moisture very easily.)

4.	The compressor oil must be stored in steel containers, not in plastic containers.

Compressor Oil Check

The oil used to lubricate the compressor circulates with the refrigerant.

Whenever replacing any component of the system or a large amount of gas leakage occurs, add oil to maintain the original amount of oil.

Oil total volume in system

FD46XG (IDEMITSU) 110 ± 10 cc (3.88 ± 0.35 oz.)

Oil Return Operation

There is close affinity between the oil and refrigerant.

During normal operation, part of the oil recirculates with the refrigerant in the system. When checking the amount of oil in the system, or replacing any component of the system, the compressor must run in advance for oil return operation. The procedure is as follows:

1.	Open all the doors and engine hood.

2.	Start the engine and air conditioning switch to "ON" and set the blower motor control knob at its highest position.

3.	Run the compressor for more than 20 minutes between 800 and 1,000 rpm in order to operate the system.

4.	Stop the engine.

Components and Components Location

Component Location Index Engine Room 1. Expansion valve2. Service port (Low pressure)3. Service port (High pressure)4. A/C Pressure transducer (APT)5. Compressor6. Discharge hose 7. Suction & ...

Refrigerant Line Components and Components Location

Components Location 1. Refrigerant Line Assembly ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Checking the tire inflation pressure
1. After driving approximately 7~10 km (4~6 miles or about 10 min), stop at a safety location. 2. Connect the filling hose (3) directly into the compressor 3. Connect the other end of the filling hose (3) directly into the valve. 4. Plug the compressor power cord into the vehicle power outl ...

Hyundai Elantra AD (2016-2020) Service Manual: Variable Charge Motion Actuator (VCMA) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the VCMA connector. 3. Check that the VCMA is not stuck by foreign material. 4. Measure resistance between motor (+) and (-) control terminals of the motor. 5. Check that the resistance is within the specification. Sp ...