Hyundai Elantra: Heating, Ventilation and Air Conditioning / Heater
- Heater Unit Components and Components Location
- Heater Unit Repair procedures
- Heater Core Repair procedures
- PTC Heater Description and Operation
- PTC Heater Repair procedures
- Evaporator Core Repair procedures
- Temperature Control Actuator Components and Components Location
- Temperature Control Actuator Description and Operation
- Temperature Control Actuator Specifications
- Temperature Control Actuator Repair procedures
- Mode Control Actuator Components and Components Location
- Mode Control Actuator Description and Operation
- Mode Control Actuator Specifications
- Mode Control Actuator Repair procedures
- Auto Defoging Actuator Components and Components Location
- Auto Defoging Actuator Description and Operation
- Auto Defoging Actuator Specifications
- Auto Defoging Actuator Repair procedures
Cluster Ionizer Repair procedures
Inspection
1.
Press the MODE switch more then 4 times within 2 seconds while pressing the OFF switch.
DisplayFail description00Normal51Cluster ion generator fault
* For diagnostic procedur ...
Heater Unit Components and Components Location
Component Location
1. Heater unit assembly
Compoents
1. Shower duct [LH]2. Heater core cover3. Heater core & Seal assembly4. Mode actuator5. Temperature control actuator [LH]6. PTC Heat ...
Other information:
Hyundai Elantra AD (2016-2020) Owners Manual: Seat Warmers. Rear seat warmers
Front seat warmers (if equipped)
Seat warmers are provided to warm the seats during cold weather.
WARNING
The seat warmers can cause a SERIOUS BURN, even at low temperatures and especially
if used for long periods of time. Passengers must be able to feel if the seat is
becoming too warm so th ...
Hyundai Elantra AD (2016-2020) Service Manual: Camshaft Position Sensor (CMPS) Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification : Refer to "Wave Form"
Removal
•
DON’T remove the camshaft position sensor during engine
running or right after engine stops, or a scald by the flowed out engine
...
