Hyundai Elantra: Heater / Mode Control Actuator Specifications

Specifications
Door position
Voltage (V)
Error detecting
Max. cooling
0.3 ± 0.15
Low voltage : 0.1V or less
Max. heating
4.7 ± 0.15
High voltage : 4.9V or more

Mode Control Actuator Description and Operation
Description The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. ...

Mode Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Components and Components Location
Components 1. Timing chain cover2. Outer roter3. Inner roter4. Oil pump cover5. Relief plunger6. Relief spring7. Relief plug8. O-ring (suction side)9. O-ring (discharge side)10. Oil screen gasket11. Oil screen12. Oil pan13. Oil filter14. Oil pressure switch (OPS) ...

Hyundai Elantra AD (2016-2020) Service Manual: Variable Intake Solenoid (VIS) Valve Description and Operation
Description Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The ECM opens or closes this valve according to engine condition (Refer to below table). Engine cond ...

© 2018-2026 www.helantraad.com