Hyundai Elantra: Heater / Temperature Control Actuator Description and Operation

Hyundai Elantra AD (2016-2020) Service Manual / Heating, Ventilation and Air Conditioning / Heater / Temperature Control Actuator Description and Operation

Description
The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.
The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temperature door.
Temperature Control Actuator Components and Components Location
Components Location 1. Temperature control actuator [LH]2. Temperature control actuator [RH] ...

Temperature Control Actuator Specifications
Specifications Door PositionVoltage (V)Error DetectingMax. cooling0.3 ± 0.15 Low voltage : 0.1V or less High voltage : 4.9V or moreMax. heating4.7 ± 0.15 ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Immobilizer System
The immobilizer system protects your vehicle from theft. If an improperly coded key (or other device) is used, the engine's fuel system is disabled. When the ignition switch is placed in the ON position, the immobilizer system indicator should come on briefly, then go off. If the indicator ...

Hyundai Elantra AD (2016-2020) Service Manual: Rear Door Belt Inside Weatherstrip Repair procedures
Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Remove the rear door belt inside weatherstrip (A). 3. To intall, reverse the removal procedure.     • When installing, install it by first contacting the inside part (basis point ...

© 2018-2026 www.helantraad.com