Hyundai Elantra: Heater / Auto Defoging Actuator Components and Components Location
| Components Location |
| 1. Auto logging actuator |
Mode Control Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode control actuator operates to the defrost mode when connecting 12V to ...
Auto Defoging Actuator Description and Operation
Description
The auto defogging sensor is installed on front window glass.
The sensor judges and sends signal if moisture occurs to blow out wind
for defogging. The air conditioner control modul ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Input Speed Sensor Description and Operation
Description
Input speed sensor is a vital unit that measures the rate of
rotation of the input shaft inside the transaxle and delivers the
readings to the TCM. The sensor provides critical input data that's used
in feedback control, damper clutch control, gear setting control, line
pressu ...
Hyundai Elantra AD (2016-2020) Service Manual: Description and Operation
Description
BSD is a system that uses two magnetic wave radar sensors
attached on the rear panel to measure the distance from the following
vehicles and provides the sensing and (visual and auditory) alarm of any
vehicle coming into the blind spot.
-
Blind Spot Detection (BSD) : Senses o ...
