Hyundai Elantra: Heater / Auto Defoging Actuator Description and Operation

Description
The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuator, A/C, auto defogging actuator, blower motor rpm and mode actuator.
Auto Defoging Actuator Components and Components Location
Components Location 1. Auto logging actuator ...

Auto Defoging Actuator Specifications
Specifications Door positionVoltage (V)Error detectingMax. cooling0.3 ± 0.15Low voltage : 0.1V or lessMax. heating4.7 ± 0.15High voltage : 4.9V or more ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Description and Operation
Description TREAD Lamp - Tire Under Inflation / Leak Warning. 1. Turn on condition A. When tire pressure is below allowed threshold B. When rapid leak is detected by the sensor. C. Indicates that tire needs to be re-inflated to placard pressure / repaired. 2. Turn off condi ...

Hyundai Elantra AD (2016-2020) Service Manual: ESC Control Unit Repair procedures
Removal 1. Turn the ignition switch OFF and then disconnect the negative (-) battery cable. 2. Pull up the lock of the HECU connector (A) , then disconnect the connector. 3. Remove the brake fluid from the master cylinder reservoir with a syringe.     • Be sure to ...

© 2018-2026 www.helantraad.com