Hyundai Elantra: Heater / Mode Control Actuator Description and Operation

Hyundai Elantra AD (2016-2020) Service Manual / Heating, Ventilation and Air Conditioning / Heater / Mode Control Actuator Description and Operation

Description

The mode control actuator is located at the heater unit.

It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent > Bi-Level > Floor > Mix.

Mode Control Actuator Components and Components Location

Components Location 1. Mode control actuator ...

Mode Control Actuator Specifications

Specifications Door positionVoltage (V)Error detectingMax. cooling0.3 ± 0.15 Low voltage : 0.1V or lessMax. heating4.7 ± 0.15 High voltage : 4.9V or more ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Front Wheel Speed Sensor Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub . Tightening torque: 107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft) • Be careful not to dam ...

Hyundai Elantra AD (2016-2020) Owners Manual: Resetting the System
The last break time is set to 00:00 and the driver's attention level is set to 5 (very attentive) when the driver resets the Driver Attention Warning (DAW) system. The Driver Attention Warning (DAW) system resets in the following situations. - The engine is turned OFF. - The drive ...