Hyundai Elantra: Body (Interior and Exterior) / Front Seat

Rear Bumper beam Assembly Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Components and Components Location
Components [General Type] 1. Front seat headrest2. Front seat headrest guide3. Front seat back board4. Front seat back frame assembly5. Front seat shield inner cover6. Front seat SAB module7. ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: 35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check that the ...

Hyundai Elantra AD (2016-2020) Service Manual: ATF Warmer Repair procedures
Removal 1. Remove the under cover. (Refer to Engine Mechanical System - "Engine room under cover") 2. Loosen the drain plug and drain the engine coolant. (Refer to Cooling System - "Coolant") 3. Disconnect the cooling hose (A) after separated the clamp. 4. Disconnect the hose (A ...

© 2018-2023 www.helantraad.com