Hyundai Elantra: Front Seat / Front Seat Cushion Cover Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Cushion Cover Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the front seat assembly. (Refer to Front Seat - "Front Seat Assembly")

2.	Remove the front seat shield inner cover. (Refer to Front Seat - "Front Seat Inner Cover")

3.	Remove the front seat shield outer cover. (Refer to Front Seat - "Front Seat Outer Cover")

4.	Remove the front seat lower protector (A).

5.	Separate the clip and remove the air ventilation duct (A).

6.	Disconnect the front seat motor connectors (A).

7.	Remove the protector (A) from the front seat cushion frame. [Center] [LH] [RH]

8.	Remove the front seat cushion cover (A) from the front seat cushion frame.

After removing the Velcro tape (A) and hog-ring clips (B) inside the front seat cushion cover, remove the seat cushion cover (C).

•	Be careful not to allow the sponge insert wire to separated in its place.

10.

To intall, reverse the removal procedure.

•	Make sure that the connectors are connected completely

•	Replace any damaged clips (or pin-type retainers).

•	To prevent wrinkles, make sure that the cover (B) is stretched evenly before connecting the hog-ring clips (A).

•	Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).

Front Seat Cushion Cover Components and Components Location

Component Location 1. Front seat cushion cover ...

Front Seat Frame Assembly Components and Components Location

Component Location 1. Front seat back frame assembly2. Front seat cushion frame assembly ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Blind-spot Collision Warning (BCW)
System Description Blind-Spot Collision Warning (BCW) The Blind-Spot Collision Warning (BCW) system uses radar sensors in the rear bumper to monitor and warn the driver of an approaching vehicle in the driver's blind spot area. 1) Blind-Spot Area The blind spot detection range varies r ...

Hyundai Elantra AD (2016-2020) Owners Manual: Safe Exit Assist (SEA) System
Once the system decides it is dangerous for a passenger to open a car door by sensing the approaching of a car from behind when the person is opening the door, the warning message "Watch for traffic" appears and the alarming sound will continue for five seconds. If a car approachi ...