Hyundai Elantra: Front Seat / Front Seat Frame Assembly Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the front seat back cover. (Refer to Front Seat - "Front Seat Back Cover")

2.	Remove the front seat cushion cover. (Refer to Front Seat - "Front Seat Cushion Cover")

3.	Remove the side airbag (SAB) module. (Refer to Airbag Module - "Side Airbag (SAB) Module")

4.	Remove the lumbar support assembly. (Refer to Body Electrical System - "Lumbar Support Unit")

After loosening the mounting bolts, detach the front seat back frame assembly (A) from the front seat cushion frame assembly (B).

Tightening torque :

44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)

To intall, reverse the removal procedure.

•	For the seat equipped with side airbag, remove the side airbag from the seat frame assembly. (Refer to Restraint - "Side Airbag (SAB) Module")

•	Before service, be fully aware of precautions and service procedure relevant to air bag. (Refer to Restraint - "Side Airbag (SAB) Module")

Component Location 1. Front seat back frame assembly2. Front seat cushion frame assembly ...

...

Hyundai Elantra AD (2016-2020) Service Manual: ETC (Electronic Throttle Control) System Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Throttle AngleOutput Voltage (V)TPS 1TPS 2C.T0.54.5W.O.T4.410.59 ETC Motor 1. Turn the ignition ...