Hyundai Elantra: Front Seat / Front Seat Shield Inner Cover Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Shield Inner Cover Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the front seat assembly. (Refer to Front Seat - "Front Seat Assembly")

2.	Loosen the screws and remove the front seat shield inner cover (A).

To intall, reverse the removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Front Seat Shield Inner Cover Components and Components Location

Component Location 1. Front seat shield inner cover ...

Front Seat Back Cover Components and Components Location

Component Location 1. Front seat back cover ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Water Temperature Control Assembly Components and Components Location
Components 1. Water temperature control assembly2. Engine coolant temperature sensor3. Throttle body coolant hose (if equipped) ...

Hyundai Elantra AD (2016-2020) Service Manual: Lumber Support Units Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front seat assembly. (Refer to Body - "Front Seat Assembly") 3. Remove the seat back. (Refer to Body - "Front Seat Back Cover") 4. Disconnect the lumber support motor connector (A). 5. Separate the retaining ...