Hyundai Elantra: Front Seat / Front Seat Shield Outer Cover Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Shield Outer Cover Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the front seat outer shield cover (A) by pulling forward in the direction of the arrow using screw driver or remover.

2.	Disconnect the front seat power switch connector (A).

To intall, reverse the removal procedure.

•	Make sure the connector is plugged in properly.

•	Replace any damaged clips (or pin-type retainers).

Front Seat Shield Outer Cover Components and Components Location

Component Location 1. Front seat shield outer cover ...

Front Seat Shield Inner Cover Components and Components Location

Component Location 1. Front seat shield inner cover ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Auto Defogging Sensor Description and Operation
Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling ...

Hyundai Elantra AD (2016-2020) Service Manual: Rear Seat Assembly Repair procedures
Replacement [Rear seat cushion assembly] 1. Loosen the mounting bolts, remove the rear seat cushion assembly (A). 2. Disconnect the rear seat cushion extension connector (A). 3. To install, reverse the removal procedure. [Rear seat back assembly] 1. Remove the rear seat cushion ass ...