Hyundai Elantra: Restraint / SRSCM
- Components and Components Location
- Schematic Diagrams
- SRS Control Module (SRSCM) Components and Components Location
- SRS Control Module (SRSCM) Description and Operation
- SRS Control Module (SRSCM) Repair procedures
- Front Impact Sensor (FIS) Components and Components Location
- Front Impact Sensor (FIS) Description and Operation
- Front Impact Sensor (FIS) Repair procedures
- Side Impact Sensor (SIS) Components and Components Location
- Side Impact Sensor (SIS) Description and Operation
- Side Impact Sensor (SIS) Repair procedures
- Seat Belt Buckle Switch (BS) Components and Components Location
- Seat Belt Buckle Switch (BS) Description and Operation
- Seat Belt Buckle Switch (BS) Repair procedures
- Occupant Classification System (OCS) Components and Components Location
- Occupant Classification System (OCS) Description and Operation
- Occupant Classification System (OCS) Repair procedures
Repair procedures
Component Replacement After Deployment
•
Before doing any SRS repairs, use the GDS Pro to check for
DTCs. Refer to the Diagnostic Trouble Code list for repairing of the ...
Components and Components Location
Components
1. Front right Pressure Impact Sensor (FIS)2. Supplemental Restraint System Control Module (SRSCM)3. Front left Pressure Impact Sensor (FIS)4. Gravity Side Impact Sensor (G-SIS)5. Pres ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Front Oil Seal Repair procedures
Replacement
1.
Remove the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pulley")
2.
Remove the front oil seal (A).
3.
Apply engine oil on the edge of new oil seal.
•
Remove any debris from the lip portion of the oil seal.
4.
...
Hyundai Elantra AD (2016-2020) Service Manual: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).
4.
Measure resistance between sensor signal terminal and sensor ground terminal.
5.
Check that the ...
