Hyundai Elantra: SRSCM / Seat Belt Buckle Switch (BS) Description and Operation

Hyundai Elantra AD (2016-2020) Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS) Description and Operation

Description
The SRSCM should detect the condition of seat belt buckles (BS) of the driver and passenger seats.
The SRSCM provides two pins to each side, in order to enter the condition of seat belt buckles (BS) of the driver and passenger seats.
The seat belt buckle circuit is operated using internal boost voltage supplied by the SRSCM, and uses body ground for signal return.
Seat Belt Buckle Switch (BS) Components and Components Location
Components 1. Seat Belt Buckle Switch (BS) ...

Seat Belt Buckle Switch (BS) Repair procedures
Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat assembly. (Refer to Body - "Front Seat Assembly") 3. ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Front Wheel Guard Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Take care not to scratch the body surface. ...

Hyundai Elantra AD (2016-2020) Service Manual: Antenna Coil Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column shroud panel. (Refer to Body - "Steering Column Shroud Panel") 3. Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw. Installation 1 ...

© 2018-2023 www.helantraad.com