Hyundai Elantra: SRSCM / Front Impact Sensor (FIS) Description and Operation

Hyundai Elantra AD (2016-2020) Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Description and Operation

Description
The front impact sensors (FIS) are installed on the upper of the side panel in Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at their mounting locations.
The primary purpose of the Front Impact Sensor (FIS) is to provide an indication of a collition. The Front Impact Sensor (FIS) sends acceleration data to the SRSCM.
Front Impact Sensor (FIS) Components and Components Location
Components 1. Front right Impact Sensor (FIS)2. Front left Impact Sensor (FIS) ...

Front Impact Sensor (FIS) Repair procedures
Removal     • Removal of the airbag must be performed according to the precautions/ procedures described previously. • Before disconnecting the front impact sensor co ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Front Hub / Knuckle Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from the front hub. Tightening torque : 107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)     • Be careful not to ...

Hyundai Elantra AD (2016-2020) Service Manual: Blower Unit Components and Components Location
Component Location 1. Blower unit assembly Components 1. Seal2. Intake duct case3. Intake actuator4. Intake door5. Intake duct case [A]6. Air filter cover7. Air filter8. Blower unit pad9. Blower upper case10. Cluster ionizer11. Blower lower case12. Power mosfet13. Resistor14. Blower moto ...

© 2018-2023 www.helantraad.com