Hyundai Elantra: SRSCM / Front Impact Sensor (FIS) Components and Components Location
| Components |
| 1. Front right Impact Sensor (FIS) | 2. Front left Impact Sensor (FIS) |
SRS Control Module (SRSCM) Repair procedures
Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3.
Remove the floor console.
(Refe ...
Front Impact Sensor (FIS) Description and Operation
Description
•
The front impact sensors (FIS) are installed on the upper of
the side panel in Front End Module (FEM). They are remote sensors that
detect acceleration due to a collision at ...
Other information:
Hyundai Elantra AD (2016-2020) Service Manual: Water Temperature Control Assembly Repair procedures
Removal and Installation
1.
Remove the engine cover.
(Refer to Engine And Transaxle Assembly - “Engine Cover”)
2.
Drain the engine coolant so its level is below water temperature control assembly.
(Refer to Cooling System - "Coolant")
3.
Remove the air duct and air cleaner assembly ...
Hyundai Elantra AD (2016-2020) Service Manual: Components and Components Location
Components
1. Timing chain cover2. Outer roter3. Inner roter4. Oil pump cover5. Relief plunger6. Relief spring7. Relief plug8. O-ring (suction side)9. O-ring (discharge side)10. Oil screen gasket11. Oil screen12. Oil pan13. Oil filter14. Oil pressure switch (OPS)
...
