Hyundai Elantra: General Information / Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Restraint / General Information / Repair procedures

Component Replacement After Deployment

•	Before doing any SRS repairs, use the GDS Pro to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs.

When the front airbag(s) deployed after a collision, replace the following items.

SRSCM

-	Deployed airbag(s)

-	Seat belt pretensioner(s)

-	Emergency fastening device(s)

-	Front impact sensors

-	SRS wiring harnesses

-	Inspect the clock spring for heat damage. If any damage found, replace the clock spring.

When the side/curtain airbag(s) deployed after a collision, replace the following items.

SRSCM

-	Deployed airbag(s)

-	Side impact sensor(s) for the deployed side(s)

-	SRS wiring harnesses

-	Seat belt pretensioner(s)

-	Emergency fastening device(s)

After the vehicle is completely repaired, confirm the SRS airbag system is OK.

-	Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off.

Description and Operation

Warning Lamp Activation Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the warning lamp for a LED lamp c ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Air Cleaner Repair procedures
Removal and Installation Air Cleaner Assembly 1. Remove the engine cover. (Refer to Engine And Transaxle Assembly - “Engine Cover”) 2. Disconnect the battery negative terminal. 3. Remove the air duct (A). 4. Disconnect the breather hose (A). 5. Disconnect the intake hose ...

Hyundai Elantra AD (2016-2020) Service Manual: Front Axle Assembly
Front Hub / Knuckle Components and Components Location Components 1. Brake disc2. Hub bearing3. Dust cover4. Knuckle Front Hub / Knuckle Repair procedures Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel ...