Hyundai Elantra: Rear Bumper / Rear Bumper beam Assembly Components and Components Location

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper beam Assembly Components and Components Location

Component Location

1. Rear bumper beam assembly


Rear Bumper Cover Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Rear Bumper beam Assembly Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Troubleshooting
Standard Flow of Diagnostic Troubleshooting Notes With Regard To Diagnosis The phenomena listed in the following table are not abnormal. ConditionExplanationSystem check soundWhen starting the engine, a thudding sound can sometimes be heard coming from inside the engine compartment. This is bec ...

Hyundai Elantra AD (2016-2020) Service Manual: Oil Pressure Switch Repair procedures
Removal and Installation 1. Disconnect the oil pressure switch connector (A) and then remove the oil pressure switch (B). Tightening torque : 9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft) 2. Install in the reverse order of removal.     • When installing the o ...

© 2018-2023 www.helantraad.com