Hyundai Elantra: Rear Bumper / Rear Bumper Cover Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper Cover Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the combination lamp cover (A).

2.	Disconnect the mounting nuts and rear combination lamp connector (A).

3.	Remove the rear combination lamp (A).

4.	Loosen the mounting clips and nuts, remove the rear bumper retainer cover (A).

5.	Loosen the mounting bolts.

6.	Disconnect the rear bumper connector (A).

After loosening the pin-type retainers and screws on the side of rear bumper (A), detach the side part of rear bumper.

•	Be careful not to damage the tabs on the side part of front bumper.

8.	Remove the rear bumper cover (A).

To intall, reverse the removal procedure.

•	Make sure the connector is plugged in properly.

•	Replace any damaged clips (or pin-type retainers).

Rear Bumper Cover Components and Components Location

Component Location 1. Rear bumper cover ...

Rear Bumper beam Assembly Components and Components Location

Component Location 1. Rear bumper beam assembly ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Battery Description and Operation
Description [AGM Battery] AGM battery is used for especially heavy load on the vehicle network depending on equipment and requirements. AGM stands for Absorbent Glass Material Battery; that is absorbent glass fibre fleece. AGM batteries are fitted in models with electrical loads/consumers ...

Hyundai Elantra AD (2016-2020) Owners Manual: To Convert to Cruise Control Mode
The driver may choose to switch to use the conventional Cruise Control mode (speed only control function) by following these steps: 1. Push the CRUISE button on the steering wheel to turn the system on. The cruise ( ) indicator will illuminate. 2. Push and hold the Vehicle-to- Vehicle Distance ...