Hyundai Elantra: Maintenance / Light Bulbs

Consult an authorized HYUNDAI dealer to replace most vehicle light bulbs. It is difficult to replace vehicle light bulbs because other parts of the vehicle must be removed before you can get to the bulb. This is especially true for removing the headlamp assembly to get to the bulb(s).

Removing/installing the headlamp assembly can result in damage to the vehicle.

Information

After heavy driving, rain or washing, headlamp and trunk lenses could appear frosty. This condition is caused by the temperature difference between the lamp inside and the outside temperature. This is similar to the condensation on your windows inside your vehicle during the rain and doesn’t indicate a problem with your vehicle. If the water leaks into the lamp bulb circuitry, have your vehicle checked by an authorized HYUNDAI dealer.

Information - Desiccant (if equipped)

This vehicle is equipped with desiccant to reduce fogging inside the headlamp due to moisture.

The desiccant is consumable and its performance may change based on the used period or environment.

If fogging inside the headlamp due to moisture continues for a long time, have your vehicle checked by an authorized HYUNDAI dealer.

WARNING

Fuse/Relay Panel Description
Instrument panel fuse panel Inside the fuse/relay box cover, you can find the fuse/relay label describing fuse/relay name and capacity. Information Not all fuse panel descriptions in this manua ...

Headlamp, Parking Lamp, Turn Signal Lamp and Side Marker
Type A (1) Headlamp (High & Low) (2) Daytime running lamp (DRL)&Parking lamp (3) Turn signal lamp (4) Side marker Headlamp (Halogen bulb) WARNING Handle halogen bulbs with care. ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Dynamic Damper Components and Components Location
Components 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper7. Shaft8. TJ boot band9. TJ boot10. Spider assembly11. Snap ring12. TJ housing13. Clip ...

Hyundai Elantra AD (2016-2020) Service Manual: PTC Heater Repair procedures
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows. 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch. (3) Press the intake (recirculation) button 5 times or more. (4) \Indicators ...

© 2018-2024 www.helantraad.com