Replacement |
1. |
Remove the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pulley") |
2. |
Remove the front oil seal (A). |
3. |
Apply engine oil on the edge of new oil seal.
|
4. |
Using the SST (09231-2E000), install a front oil seal (A).
|
5. |
Install the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pulley") |
Hyundai Elantra AD (2016-2020) Service Manual: Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).
4.
Measure resistance between sensor signal terminal and sensor ground terminal.
5.
Check that the ...
Hyundai Elantra AD (2016-2020) Owners Manual: Smooth Cornering, Driving at Night
Smooth Cornering
Avoid braking or gear changing in corners, especially when roads are wet. Ideally,
corners should always be taken under gentle acceleration. Driving at Night
Night driving presents more hazards than driving in the daylight. Here are some
important tips to remember:
Slow do ...