| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the trunk lid panel.
(Refer to Body - "Trunk Lid Trim") |
| 3. |
Remove the license lamp (A) after disengaging the license lamp mounting clip (B).
|
| 4. |
Replace the bulb (A) after removing a lens.
|
| Installation |
| 1. |
Install the license lamp assembly. |
| 2. |
Install the trunk lid panel. |
| 3. |
Connect the negative (-) battery terminal. |
Front Fog Lamps Repair procedures
High Mounted Stop Lamp Repair proceduresHyundai Elantra AD (2016-2020) Service Manual: Transaxle Control Module (TCM) Repair procedures
Inspection
Transaxle Control Module(TCM) Problem Inspection Procedure
1.
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and
chassis ground using the backside of TCM harness connector as TCM side
check point. If the problem is found, repair it.
Specification: Below 1?
2.
TE ...
Hyundai Elantra AD (2016-2020) Service Manual: Seat Heater Switch Schematic Diagrams
Circuit Diagram
[Front Seat Heater Switch (Driver)]
[Front Seat Heater Switch (Passenger)]
[Rear Seat] ...