Hyundai Elantra: Lighting System / Front Fog Lamps Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
3.
Disconnect the front fog lamp connector (A).
4.
Remove the front fog lamp assembly (A) after loosening the mounting nut.

Installation
1.
Install the front fog lamp assembly.
2.
Connect the front fog lamp connector.
3.
Install the front bumper.
4.
Connect the negative (-) battery terminal.
Rheostat Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Disconnect the rheostat switch connector (A). ...

License Lamps Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the trunk lid panel. (Refer to Body - "Trunk Lid Trim") 3. Remove the license lamp (A) after disengaging the license lam ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Detecting Sensor
The rear radars are located inside the rear bumper for detecting the side and rear areas. Always keep the rear bumper clean for proper operation of the system. NOTICE The system may not work properly when the bumper has been damaged, or if the rear bumper has been replaced or repaired. ...

Hyundai Elantra AD (2016-2020) Service Manual: Power Window Switch Schematic Diagrams
Circuit Diagram Driver Power Window Switch [Driver Power Window Switch (Safety)] [Driver Power Window Switch (Auto Down)] Assist Power Window Switch Rear Power Window Switch [Rear Power Window Switch (Manual)] [Rear Power Window Switch (Manual + Seat Heater)] ...

В© 2018-2025 www.helantraad.com