Hyundai Elantra: Lighting System / High Mounted Stop Lamp Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body Electrical System / Lighting System / High Mounted Stop Lamp Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the rear package tray trim. (Refer to Body - "Rear Package Tray Trim")

3.	Remove the high mounted stop lamp assembly (A) after loosening the mounting nuts.

Installation

1.	Install the rear high mounted stop lamp.

2.	Install the package tray trim.

3.	Connect the negative (-) battery terminal.

License Lamps Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the trunk lid panel. (Refer to Body - "Trunk Lid Trim") 3. Remove the license lamp (A) after disengaging the license lam ...

Rear Combination Lamp Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the outside rear combination lamp assembly (B) after disconnecting the connector (A). 3. Remove the bulb (A) after turnin ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Description and Operation
Description LKAS (Lane Keeping Assist System) : The system is designed to help recognize the lane ahead and to give off a lane departure warning when the vehicle starts moving out of the lane by using the camera image and vehicle signal information. LKAS Controller Typical Operating Condit ...

Hyundai Elantra AD (2016-2020) Service Manual: Idler Repair procedures
Removal and Installation 1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the idler (A). Tightening torque : 39.2 ~ 49.0N.m (4.0 ~ 5.0kgf.m, 28.9 ~ 36.2lb-ft) 3. Install in the reverse order of removal. Inspection Check the idler for excessive oil le ...