Hyundai Elantra: Crash Pad / Crash Pad Under Cover Repair procedures

Replacement
   
•
Put on gloves to prevent hand injuries.
   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the crash pad under cover [RH] (A).

2.
To intall, reverse the removal procedure.
   
•
Replace any damaged clips (or pin-type retainers).
Crash Pad Side Cover Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Glove Box Upper Cover Housing Components and Components Location
Component Location 1. Glove box upper cover housing ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check that the ...

Hyundai Elantra AD (2016-2020) Owners Manual: Good Driving Practices
Never move the shift lever from P (Park) or N (Neutral) to any other position with the accelerator pedal depressed. Never move the shift lever into P (Park) when the vehicle is in motion. Be sure the vehicle is completely stopped before you attempt to shift into R (Reverse) or D (Drive ...

© 2018-2026 www.helantraad.com