Hyundai Elantra: Engine Control System / Camshaft Position Sensor (CMPS) Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Engine Control/Fuel System / Engine Control System / Camshaft Position Sensor (CMPS) Repair procedures

Inspection

Check the signal waveform of the CMPS and CKPS using the GDS.

Specification : Refer to "Wave Form"

Removal

•	DON’T remove the camshaft position sensor during engine running or right after engine stops, or a scald by the flowed out engine oil may occur.

[Bank 1 / Intake]

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the camshaft position sensor connector (B) after removing the clip (A).

3.	Remove the installation bolt (C), and then remove the sensor.

[Bank 1 / Exhaust]

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the camshaft position sensor connector (B) after removing the clip (A).

3.	Remove the installation bolt (C), and then remove the sensor.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

•	Apply the engine oil to the O-ring.

•	Insert the sensor in the installation hole and be careful not to damage when installation.

•	Be careful not to damage the sensor housing and the connector.

•	Be careful not to damage the O-ring.

Installation is reverse of removal.

Camshaft position sensor installation bolt :

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Camshaft Position Sensor (CMPS) Schematic Diagrams

Circuit Diagram ...

Knock Sensor (KS) Description and Operation

Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knockin ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Additional Safety Precautions
Passengers should not move out of or change seats while the vehicle is moving. A passenger who is not wearing a seat belt during a crash or emergency stop can be thrown against the inside of the vehicle, against other occupants, or be ejected from the vehicle. Do not use any accessories on s ...

Hyundai Elantra AD (2016-2020) Service Manual: Intake Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the intake actuator operates to the recirculation position w ...