Hyundai Elantra: Lighting System / Rheostat Repair procedures

Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")

3.
Disconnect the rheostat switch connector (A).

4.
Check for intensity of new rheostat switch. If the light intensity of the lamps changes smoothly without any flickering when the rheostat is turned, it can be assumed that the rheostat is normal.

Rheostat Components and Components Location
Components ...

Front Fog Lamps Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper. (Refer to Body - "Front Bumper Cover") 3. Disconnect the front fog lamp connector (A). 4. Remove t ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Repair procedures
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with an PCM(ECM) request for vehicle specific data (PIN code: 6digits) from the tester. The "virgin" PCM ...

Hyundai Elantra AD (2016-2020) Service Manual: Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check that the ...

© 2018-2022 www.helantraad.com