Hyundai Elantra: Crash Pad / Crash Pad Side Cover Repair procedures

Replacement
   
•
Put on gloves to prevent hand injuries.
   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the crash pad side cover (A).
[LH]

[RH]

2.
To intall, reverse the removal procedure.
   
•
Replace any damaged clips (or pin-type retainers).
Crash Pad Side Cover Components and Components Location
Component Location [LH] 1. Crash pad side cover [LH] [RH] 1. Crash pad side cover [RH] ...

Crash Pad Under Cover Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Brake Pedal Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the stop lamp switch connector (A). 4. Remove the wiring fixed clip from the brake pedal member. 5. Remove the bra ...

Hyundai Elantra AD (2016-2020) Service Manual: Fuel Tank Pressure Sensor (FTPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Specification : Refer to "Specification" Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the rear seat. (Refer to Body ...

© 2018-2025 www.helantraad.com