Hyundai Elantra: Rear Seat / Rear Seat Cushion Cover Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Cushion Cover Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")

2.	After removing the Velcro tape (A) and hog-ring clips (B) inside the rear seat cushion cover, remove the seat cushion cover (C). [Front side] [Rear side]

To intall, reverse the removal procedure.

•	Make sure that the connectors are connected completely.

•	Replace any damaged clips (or pin-type retainers).

•	To prevent wrinkles, make sure that the cover (B) is stretched evenly before connecting the hog-ring clips (A).

•	Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).

Rear Seat Cushion Cover Components and Components Location

Component Location 1. Rear seat cushion cover ...

Rear Back Armrest Repair procedures

Replacement • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Use a plastic panel ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: 26 Brake Control Solenoid Valve(26/B_VFS) Components and Components Location
Components Location 1. 26 Brake Control Solenoid Valve (26/B)2. 35R Clutch Control Solenoid Valve (35R/C)3. Underdrive Brake Control Solenoid Valve (UD/B)4. Overdrive Clutch Control Solenoid Valve (OD/C)5. SS-A Solenoid Valve (ON/OFF)6. Torque Converter Control Solenoid Valve (T/CON)7. Line Pre ...

Hyundai Elantra AD (2016-2020) Service Manual: Front Strut Assembly Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque : 107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft) • Be careful not to dam ...