Hyundai Elantra: Front Door / Front Door Outside Handle Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Front Door / Front Door Outside Handle Repair procedures

Replacement

1.	Remove the plug hole (B).

After loosening the mounting bolt, remove the front door lock assembly (A).

Tightening torque :

7.8 ~ 10.8 N.m (0.8 ~ 1.1 kgf.m, 5.8 ~ 8.0 lb-ft)

3.	Remove the front door outside handle (A) by sliding it forward.

4.	Disconnect the front door outside handle connector (A) by pushing the locking pin.

To intall, reverse the removal procedure.

•	Make sure the connector is connected properly.

•	Make sure the door locks / unlocks and opens / closes properly.

•	Be sure to install the outside handle pad (A) between the outside handle and the door panel.

Front Door Outside Handle Components and Components Location

Component Location 1. Front door outside handle ...

Front Door Belt Outside Weatherstrip Repair procedures

Replacement 1. Pull down the front door window glass to the lowest level by pressing the power window glass switch. 2. After loosening the mounting screws, remove the front door belt outside w ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Alternator Specifications
Specification ItemSpecificationRated voltage 13.5V, 150A Speed in use 1,000 ~ 18,000 rpm Voltage regulator IC Regulator built-in type Regulator Setting Voltage External mode Refer to below graph Internal mode 14.55 ± 0.3V Temperature Gradient External mode 0 ± 3 mV / ...

Hyundai Elantra AD (2016-2020) Service Manual: SS-A Solenoid Valve(ON/OFF) Description and Operation
Description • SS-A solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. • SS-A Solenoid valve(ON/OFF) is installed at valve body. ...