Hyundai Elantra: Lighting System / Room Lamp Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body Electrical System / Lighting System / Room Lamp Repair procedures

Removal

[Room Lamp]

1.	Disconnect the negative (-) battery terminal.

Using a screwdriver or remover, Separate the room lamp lens (A) from the room lamp.

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

3.	If it is necessary to replace the bulb, remove the bulb (A) after disengaging the room lamp lens.

Disengage the room lamp (B) after loosening the mounting screws.

•	When removing the room lamp, be careful of the direction in which the tool is inserted.

•	Use caution when inserting the tool in the opposite direction, as the room lamp is damaged.

5.	Remove the room lamp assembly after disconnect the room lamp connector.

[Vanity Lamp]

1.	Separate the vanity Lamp (A) from the roof trim after disengaging the mounting clip (B).

Installation

[Room Lamp]

1.	Install the room lamp after connect the connector.

2.	Install the room lamp lens

3.	Connect the negative (-) battery terminal.

[Vanity Lamp]

1.	Install the vanity lamp.

2.	Connect the negative (-) battery terminal.

Head Lamps Repair procedures

Head Lamp Aiming Instructions [Mechanical Aiming] The head lamps should be aimed with the proper beam-setting equipment, and in accordance with the equipment manufacturer's instructions. ...

Overhead Console Lamp Repair procedures

Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. Removal 1. Disconn ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Audio Remote Control Schematic Diagrams
Circuit Diagram [Audio + B/Tooth + Voice] [Trip] [Trip / Cruise] [Trip / Cruise/ Smart Cruise] ...

Hyundai Elantra AD (2016-2020) Service Manual: Windshield Wiper-Washer Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. If it is necessary to remove multifunction switch assembly, remove the steering wheel. (Steering System - "Steering Wheel") 3. Remove the steering column upper shrouds (A). (Refer to Body - "Steering Column Shroud Panel") 4 ...