Hyundai Elantra: Lighting System / Overhead Console Lamp Repair procedures

Inspection
1.
Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mounting screws (2EA).
And then remove the overhead console (A).

3.
Remove the overhead console after disconnect the connector (A).

4.
Remove the overhead console lamp (B) by turning the socket.

Installation
1.
Install the overhead console lamp after connecting the connector.
2.
Install the lens after tightening 2 screws.
Room Lamp Repair procedures
Removal [Room Lamp] 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, Separate the room lamp lens (A) from the room lamp.     • Put o ...

Hazard Lamp Switch Repair procedures
Inspection 1. Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch. Manual (Auto) Removal     • Wrap the protec ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Description and Operation
Description System Overview The System offers the following features: - Human / machine interface through a 1-stage button, for terminal switching and engine start. - Control of external relays for ACC / IGN1 / IGN2 terminal switching and STARTER, without use of mechanical ignition swit ...

Hyundai Elantra AD (2016-2020) Service Manual: Input Speed Sensor Repair procedures
Inspection 1. Using the GDS, check the input/output speed sensor waveforms. A. Turn OFF the ignition switch. B. Connect the GDS to the Data Link Connector(DLC) on the lower crash pad. C. Ignition "ON" & Engine "ON". D. Check the input/output speed sensor waveforms at high spe ...

© 2018-2026 www.helantraad.com