Hyundai Elantra: Automatic Transaxle Control System / Input Speed Sensor Description and Operation

Description
Input speed sensor is a vital unit that measures the rate of rotation of the input shaft inside the transaxle and delivers the readings to the TCM. The sensor provides critical input data that's used in feedback control, damper clutch control, gear setting control, line pressure control, clutch activation pressure control, and sensor fault analysis.

Transaxle Oil Temperature Sensor Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. 3. Disconnect the solenoid valve connector (A). 4. Measure resistance between sensor signal terminal an ...

Input Speed Sensor Specifications
Specifications ? Type: Hall effect sensor ? Specifications ItemsSpecificationsOperation condition [°C(°F)](-40 ~ 150) -40 ~ 302Output voltage(V)High1.18 ~ 1.68Low0.59 ~ 0.84 ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Front Driveshaft Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque : 107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)     • Be careful not to dam ...

Hyundai Elantra AD (2016-2020) Service Manual: CVVT & Camshaft Components and Components Location
Components 1. Camshaft bearing cap2. Camshaft front bearing cap3. Exhaust camshaft4. Intake camshaft5. Exhaust CVVT assembly6. Intake CVVT assembly ...

© 2018-2026 www.helantraad.com