Hyundai Elantra: Back View Camera System / Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the trunk lide trim.
(Refer to Body - "Trunk Lid Trim")
3.
Disconnect the back view camera connector.
4.
Remove the back view camera (A) after loosening the moungting screws.

Installation
1.
Install the back view camera.
2.
Install the trunk lid trim.
3.
Connect the negative (-) battery terminal.
Description and Operation
Description Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the ...

Adaptive Front Lighting System
...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Seat Belt Pretensioner (BPT) Description and Operation
Description The Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH & RH). When a vehicle crashes with a certain degree of frontal impact, the pretensioner seat belt helps to reduce the severity of injury to the front seat occupants by retracting the seat belt webbing ...

Hyundai Elantra AD (2016-2020) Owners Manual: Detecting Sensor
The rear radars are located inside the rear bumper for detecting the side and rear areas. Always keep the rear bumper clean for proper operation of the system. NOTICE The system may not work properly when the bumper has been damaged, or if the rear bumper has been replaced or repaired. ...

© 2018-2025 www.helantraad.com