Hyundai Elantra: Rear Seat Belt / Rear Seat Belt Retractor Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Seat Belt Retractor Repair procedures

Replacement

•	When installing the belt, make sure not to damage the retractor.

1.	Remove the package tray trim. (Refer to Interior Trim - "Package Tray Trim")

After loosening the mounting bolt, remove the rear seat belt lower anchor (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

Loosen the retractor (A) mounting bolt, remove the rear seat belt (B).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

[LH]

[RH]

To intall, reverse the removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Rear Seat Belt Retractor Components and Components Location

Component Location 1. Rear seat belt retractor [LH]2. Rear seat belt retractor [RH] ...

Rear Center Seat Belt Retractor Components and Components Location

Component Location 1. Rear center seat belt retractor ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Wheel Repair procedures
Hub nut tightening sequence 1. Tighten the hub nuts as follows. Tightening torque : 107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft) • When using an impact gun, final tightening torque should be checked using a torque wrench. Run out inspection 1 ...

Hyundai Elantra AD (2016-2020) Service Manual: Dynamic Damper Components and Components Location
Components 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper7. Shaft8. TJ boot band9. TJ boot10. Spider assembly11. Snap ring12. TJ housing13. Clip ...