Hyundai Elantra: Rear Seat / Rear Seat Assembly Components and Components Location

Hyundai Elantra AD (2016-2020) Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Assembly Components and Components Location

Component Location

1. Rear seat cushion assembly
2. Rear seat back assembly

Components and Components Location
Components 1. Rear seat back assembly [LH]2. Rear seat back assembly [RH]3. Rear back armrest4. Rear seat cushion assembly ...

Rear Seat Assembly Repair procedures
Replacement [Rear seat cushion assembly] 1. Loosen the mounting bolts, remove the rear seat cushion assembly (A). 2. Disconnect the rear seat cushion extension connector (A). 3. To instal ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Temperature Control Actuator Description and Operation
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by ...

Hyundai Elantra AD (2016-2020) Service Manual: Troubleshooting
Failure Diagnosis 1. In principle, ESC and TCS controls are prohibited in case of ABS failure. 2. When ESC or TCS fails, only the failed system control is prohibited. 3. However, when the solenoid valve relay should be turned off in case of ESC failure, refer to the ABS fail-safe. 4. ...

© 2018-2024 www.helantraad.com