Hyundai Elantra: Rear Seat / Rear Seat Assembly Repair procedures

Replacement
[Rear seat cushion assembly]
1.
Loosen the mounting bolts, remove the rear seat cushion assembly (A).

2.
Disconnect the rear seat cushion extension connector (A).

3.
To install, reverse the removal procedure.
[Rear seat back assembly]
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Fold the rear seat back assembly (A) by pulling the folding lever in the direction of the arrow.

3.
After loosening the mounting bolts, remove the rear seat assembly (A).

Tightening torque :
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

4.
To intall, reverse the removal procedure.
Rear Seat Assembly Components and Components Location
Component Location 1. Rear seat cushion assembly2. Rear seat back assembly ...

Rear Seat Back Cover Components and Components Location
Component Location 1. Rear seat back cover [LH]2. Rear seat back cover [RH] ...

Other information:

Hyundai Elantra AD (2016-2020) Owners Manual: Pre-tensioner seat belt (Driver and front passenger)
Your vehicle is equipped with driver's and front passenger's Pre-tensioner Seat Belts (Retractor Pretensioner and Emergency Fastening Device System). The purpose of the pre-tensioner is to make sure the seat belts fit tightly against the occupant's body in certain frontal collisi ...

Hyundai Elantra AD (2016-2020) Owners Manual: Resetting the System
The last break time is set to 00:00 and the driver's attention level is set to 5 (very attentive) when the driver resets the Driver Attention Warning (DAW) system. The Driver Attention Warning (DAW) system resets in the following situations. - The engine is turned OFF. - The drive ...

© 2018-2025 www.helantraad.com