Hyundai Elantra: Lighting System / Rear Combination Lamp Repair procedures

Hyundai Elantra AD (2016-2020) Service Manual / Body Electrical System / Lighting System / Rear Combination Lamp Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the outside rear combination lamp assembly (B) after disconnecting the connector (A).

3.	Remove the bulb (A) after turning it in the counter clock-wise direction. [LED Type] [Bulb Type]

4.	Disconnect the inside rear combination lamp connector (A) after removing the rear combination lamp cover.

5.	Remove the inside rear combination lamp assembly after loosening the nuts.

6.	If it is necessary to replace the bulb, remove the bulb after removing the tailgate cover.

Installation

1.	Install the inside combination lamp assembly after assembling the bulb.

2.	Install the rear combination lamp assembly after assembling the bulbs and connecting the lamp connector.

High Mounted Stop Lamp Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear package tray trim. (Refer to Body - "Rear Package Tray Trim") 3. Remove the high mounted stop lamp assembly (A) ...

Auto Lighting Control System

Specifications Specifications ItemsSpecificationsRated voltage5VLoadMax. 1mA (Relay load)Illuminations (LUX)501.42 ± 0.31V1002.63 ± 0.58V1503.84 ± 0.84V Components and Components Location C ...

Other information:

Hyundai Elantra AD (2016-2020) Service Manual: Special Service Tools
Special Service Tools Tool(Number and Name)IllustrationUse09581-2T100Piston expanderSpreading the front disc brake piston.09580-0U000Brake piston adjusterRemoval and installtion of the rear disc brake piston. ...

Hyundai Elantra AD (2016-2020) Service Manual: 35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check that the ...